How to make ceramic band heaters?
1.What is a ceramicband heater?
The ceramic band heater is mainly suitable for extrusion, casting and under-punching. The operating temperature can reach 450 degrees and the maximum surface load is 6.5W/cm. It is characterized by long life and high temperature resistance, 30% reduction in energy consumption and high insulation. The most suitable electric heating products for machine, injection molding machine and film blowing machine.
2.ceramic band heater specifications
|SPECIFICATIONS FOR Ceramic Band Heater|
|Material:||stainless steel, cerHow to make a ceramic band heater
amic and ni-cr resistance wire
|Inner diameter:||mini50mm-1000mm or customized|
|Volt:||110V, 120V, 200V, 220V, 230V, 240V, 400V, 480V and other can be customized|
|Terminal:||Plug/lead wire/terminal box|
3. What are the advantage of ceramic band heaters?
1). Fast heat transfer, uniform heat generation and stable operation.
2). the temperature does not leak, can save energy, the cover is not hot by hand, work safe.
3). the power of the product is high, the power of the ceramic strip is 0.5~1.5 times higher than the ordinary one.
4). High temperature heating wire imported Europe and the United States, with fast heat dissipation, uniform heating, high temperature stability, etc., can be used at 600-800 °C for a long time.
5). the product has a long service life, because the raw materials are slow to age at high temperatures, so the product has a long service life.
6). in line with the national GB technical requirements. Power deviation +5% ∽-10%.
7). Electrical strength: After sinusoidal AC voltage test with voltage of 1500v/50Hz, there is no breakdown phenomenon after 1MIN.
8). High mechanical strength, good thermal insulation performance, large contact surface with heated objects and long service life.
9). easy to install, maintain, low cost, even if the internal heating material is damaged, and the external ceramic devices can still be reused.
4.Ceramic Band Heater Application:
- Heating barrels of plastic injection molding machines and extruders
- Die and die holder heating of plastic extruders and blow molding machines
- Burn-out ovens
- Heated kettles
- Fluidized beds
- Heat treating pipes
- Any application requiring heat applied to a cylindrical surface
5.How to make a ceramic band heaters?
Pls provide the Watts, Volts, Inner Diameter, Width, Lead Length, Type of leads,Options.
If you wan to know more about the ceramic band heaters, please feel free to contact us :firstname.lastname@example.org