High quality Teflon immersion heater PTFE Heater
Teflon package titanium heater:
It has good non-stickiness and strong corrosion resistance.
Low surface load design, product life is long, suitable for all kinds of corrosive liquid heating.
Voltage/power is manufactured according to user’s requirements.
The filling material for heating pipe junction boxes is usually epoxy resin, which is not available.
Fire protection performance. In order to meet the actual production safety requirements, our company fully adopts electric heating pipe (heater).
New flame retardant pouring sealant has better fire protection effect. Use safer and more assured!
Wires that exceed the national standard are used to ensure the heater.
Long-term working wires do not heat, to eliminate the wire load caused by fire this serious safety problem.
|Heat intensity||Not exceeding 30w/cm2 (advisable)|
|Power||Depends on the dimension|
|Exhaust extreme (when cold)||<=0.1mA to 242 v.|
|Insulation (when cold)||5 Min Ohms 500 Watts minimum|
|Dielectric strength||1500v. 1/sec|
|Working temperature||650 Deg C max.|
|Diameter tolerance||-0.02 to -0.06 mm|
|Cut off connection tolerance||+/-15 mm|
|Power tolerance (w)||+5 % – 10 %|
|Cold areas||Depends on length and diameter 5-25mm|
Water Deionized, Demineralized, Clean, Potable, Process
Industrial Water Rinse Tanks
Hydraulic Oil, Crude, Asphalt
Lubricating Oils at API Specified Watt Densities
Air and Gas Flow
Process Air Equipment